XLINE: Spray gun: HS 30 HVLP

This high-performance spray gun is suitable for processing many media. As standard, the spray gun is equipped with an air fine control so that the amount of air can be dosed individually. The built-in jet control valve enables a stepless conversion from the finest round beam to the full flat beam. This allows the beam width to be adapted to different workpieces during the spraying process. A fatigue-free work is ensured by the grippy, well balanced form. The applied plastic handle is also beneficial in continuous use, as the heavily undercooled compressed air no longer causes a cold grip. The main body is made and anodized from a corrosion-resistant light metal alloy. Material nozzles and needles are made of stainless steel as standard, but can also be supplied in hardened versions, carbide, plastic etc. for special applications.

The material feed can be done differently. There are pistols with material sockets as well as different gravity cups available. Furthermore, there is a wide range of nozzles and needles in different sizes. The spray gun can of course also be used in combination with our material containers, diaphragm pumps and controllers.

Material-touched parts

The material-touched parts of the spray guns are made of aluminium (case), stainless steel (material needle and nozzle) as well as brass and plastic (seals).
The gravity cups are made of aluminium, copper or plastic.

HVLP

The HVLP system (High Volume Low Pressure) offers a large amount of air at lower atomisation pressure. It is suitable for small and large parts. It is a low-spray system and also suitable for functional coatings. The HVLP system allows you to save a lot of material depending on the application and material.