Service individuel

Les collaborateurs compétents de notre service technique sont à votre disposition pour développer avec vous des systèmes exactement adaptés à votre cas d'application spécifique.

Système automatique d`alimentation en peinture

Description

The paint feed system is designed for the automatic supply of paints to automatic spray guns or hand-operated spraying stations. The system can also be designed for the use of water-based or solvent paints.

Paint changeover can be effected manually or via pneumatic control of the paint changeover valves. During paint changeover, a rinsing process is performed to remove paint residues from pipes, valves and the spray gun.

The paint is stored in 25-litre or 200-litre material feed containers. The system can also be connected to other sizes of container.

The delivery system equipment is mounted on lifting devices to ensure easy changeover of material feed containers.

The paint is conveyed to the draw off points through hoses and pipes. The required delivery pressure is generated by compressed air pumps.

A number of add-on units are available to improve the processing properties of the paints. For example:
 

  • compressed air stirrers can be installed in the material feed containers, and double filter assemblies can be inserted in the material feed lines
  • the material lines can be designed as circulation lines up to the material changeover valves
  • the pumps can be fitted with pressure equalisation containers to balance out pressure surges

The paint feed systems are operated and controlled exclusively with compressed air. The independent compressed air pump extracts the paint from the material feed container, and the paint is conveyed via the pressure equalisation container and the actuator valve to the double filter assemblies, where it is filtered. The material then travels from the double filter assembly through a flexible hose line into the stainless steel pipe, and from there to the paint changeover valve. 

The paint changeover valves are pneumatically controlled. Unused paint is routed back to the material feed containers via a circulation line. If the paint changeover valve is open, the paint flows to the material pressure regulator and from there to the automatic spray gun. The desired material pressure at the automatic spray gun can be variably adjusted on the material pressure regulator. The process is pneumatically controlled.

Photos/documents

Désignation Genre du document Langues
Postes de mise en peinture Liste des produits
Langues Format Grandeur
PDF 2.23 MB Télécharger
PDF 1.99 MB Télécharger
PDF 2.08 MB Télécharger
Postes de mise en peinture Liste des produits
Langues Format Grandeur
PDF 2.23 MB Télécharger
PDF 1.99 MB Télécharger
PDF 2.08 MB Télécharger